3
RBC25SS3
RBC5SS3
INTRODUCTION
The Repco 2.5 Amp and 5 Amp Automatic 9 Stage
Battery Chargers are designed to efficiently
charge most battery types; Lead-acid, Calcium*,
Maintenance Free, Gel and AGM. They are
manufactured to the latest design parameters
and highest quality levels.
The unique charging system cycles through the
various stages and may repeat the cycle three
(3) times to recondition and recharge a battery in
poor condition, or that has been left idle or stored
for a prolonged period; saving you the cost of an
expensive battery.
This manual is applicable for both 2.5 Amp and
5 Amp 9 Stage Battery Chargers as they have
the same functions with the exception of their
respective maximum output current.
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ THIS MANUAL THOROUGHLY BEFORE USE AND STORE FOR FUTURE REFERENCE.
WARNINGS
• Explosive gases. Prevent flames and sparks.
Provide adequate ventilation during charging.
• Before charging read the instructions.
• For indoor use. Do not expose to rain.
• For charging 6V and 12V rechargeable lead acid
automotive type batteries of the size detailed in
the specifications table.
• Do not attempt to charge non-rechargeable
batteries.
• Do not charge other type of batteries like Nickel
Cadmium (NiCad), Nickel-Metal Hydride (Ni-MH),
Dry-Cell etc.
• Never charge a frozen battery.
• During charging, the battery must be placed in a
well ventilated area - as far as possible from any
flame or ignition sources.
• Do not smoke whilst attending to the battery or
when in the vicinity of a battery.
• This battery charger is not intended for persons
with reduced physical, mental and/or sensory
abilities. Similarly, persons that lack experience
or knowledge (including children) should be
supervised or given suitable instruction.
• Young children should be supervised to ensure
that they do not play with the appliance.
• Disconnect the 240V mains supply before making
or breaking the connections to the battery.
• The battery charger must be plugged into an
earthed or grounded socket-outlet.
• Connection to mains supply must be in
accordance with National wiring rules
• If the AC cord is damaged do not use. Have the
cord replaced or repaired by a qualified person.
• Corrosive substances can escape from the
battery. Use suitable personal protective
equipment (PPE) including eye protection and
keep skin covered where possible. If contact
with battery acid occurs, flush the area with
plenty of water for at least 10 minutes and
promptly seek medical attention.
WARNING : ALWAYS WEAR EYE PROTECTION AND KEEP SKIN COVERED
WHEN WORKING ON OR AROUND LEAD ACID BATTERIES
To Next Page
Loading...