Replus Replus-250 - Fcc Compliance; Installation; Safety Instructions

02
03
3. FCC COMPLIANCE
2. SAFETY INSTRUCTIONS
Warning: Please Read This Manual Before Installaon. Any Damage To The Product Due To
Not Following This Manual Is Not Covered By The Warrantee. All The Installaon Should Be
Done By A Cerfied Electrician. Besides The Cable Connectors, Nothing Else On Or In
Microinverter Should Be Modified.
All Installaons Should Follow The Local Electriccodes. The Replus-250/ Replus-250A/B Does Not
Include Components That Can Be Served By Customers. Opening Or Aempng To Modify Or
Change The Construcon Or Design Of The Microinverter Shall Void The Warranty. Please Contact
Authorized Service Agents For Any Service Work.
Replus-250/ Replus-250A/B Is A Grid-ed Solar Inverter. It May Require Approval From Local
Ulity Company Prior To Grid Inter Connecon.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon
against harmful interference in a residenal installaon. This equipment can radiate energy from
radio frequencies and, if not installed and used in accordance with the instrucons, may cause
harmful interference with radio communicaons. If this equipment does cause harmful
interference to radio or television recepon, which can be determined by turning the equipment
off and on, the user is encouraged to aempt to correct interference by taking one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modificaons not expressly approved by the party responsible for compliance may
void the user’s authority to operate the equipment.
4. INSTALLATION
Warning: Be Aware That Installaon Of This Equipment Includes Risk Of Electric Shock.
Normally, Grounded Conductors Maybe Ungrounded And Energized When A Ground Fault
Is Indicated.
Parts Included
In addion to the Replus-250/ Replus-250A/B micro inverters, PV modules, rack, and associated
hardware, you’ll need the Replus-250/ Replus-250A/B installaon kit. This kit includes the
following items:
• Installaon fixed screws
• Grounding fixed washers
• User manual
• Warranty Terms and Warranty Card
Other Required Parts And Tools
In addion to your PV array and its associated hardware, you will need to provide the following:
• Juncon box
• Connuous grounding wire
• Number 2 Phillips screwdriver
• Sockets and wrenches for mounng hardware
• Torque wrench
• Mounng hardware suitable for module rack
Lightning Surge Suppression
Lightning does not actually need to strike the equipment or building where a PV system is
installed to cause damage. Oen, a strike nearby will induce surges in the electrical grid that can
potenally exceed maximum voltages and damage equipment. The Replus-250/ Replus-250A/B
has integral surge protecon, greater than most string inverters. However, if the surge has
sufficient energy, the protecon built into the Replus-250/ Replus-250A/B can be exceeded, and
the equipment can be damaged.
The ReneSola Limited Warranty does not cover “acts of God” such as lightning strikes, and since
lightning strikes can occur any where, it is recommended to install surge protecon as part of any
solar installaon. Installaon of surge protecon devices should follow vendor instrucons.