ResMed AIRCurve 10 ST User Manual

4
Setup
CAUTION
Do not overfill the water tub as water may enter the device and air tubing.
1. Place the device on a stable level surface.
2. Plug the power connector into the rear of the device. Connect one end of the power cord into
the power supply unit and the other end into the power outlet.
3. Connect the air tubing firmly to the air outlet located on the rear of the device.
4. Open the water tub and fill it with distilled water up to the maximum water level mark.
Do not fill the water tub with hot water.
5. Close the water tub and insert it into the side of the device.
6. Connect the free end of the air tubing firmly onto the assembled mask.
See the mask user guide for detailed information.
Recommended masks are available on www.resmed.com.

ResMed AIRCurve 10 ST Specifications

General

Sound Level	26.6 dBA
Data Storage	SD Card
Ramp Feature	Yes
Device Type	BiLevel Positive Airway Pressure Device
Pressure Range	2–25 cm H2O
Humidifier	Integrated HumidAir Humidifier
Operating Mode	CPAP, S, ST
Heated Tubing	Optional
Expiratory Relief	Yes
Ramp Time	0 to 45 min (5-min increments)
Display	Color LCD
Power Supply Range	100-240V AC, 50-60Hz