Need help?Do you have a question about the ResMed AirCurve 10 ST-A and is the answer not in the manual?
General| Device Type | Bi-level positive airway pressure (BiPAP) device |
|---|---|
| Pressure Range | 4 to 30 cm H2O |
| Ramp | Yes |
| IPAP Pressure Range | 4 to 30 cm H2O |
| EPAP Pressure Range | 4 to 25 cm H2O |
| Ramp Time | 0 to 45 minutes |
| Noise Level | 26 dBA |
| Altitude Adjustment | Automatic |
| Modes | ST |
| Humidification | Integrated HumidAir heated humidifier |
| Data Management | SD card |
| Power Supply | 100-240V, 50/60Hz |
| Operating Altitude | Up to 8, 500 ft |
| Therapy Modes | ST |
| Ti Control | 0.3 to 3 seconds |
| Rise Time | 1 to 6 |
| Display | LCD |
| Data Recording | Comprehensive data including usage, AHI, leak, and more |
Specifies the conditions and patient weight for which the device is indicated.
Lists pre-existing conditions where positive airway pressure therapy may be contraindicated.
Describes potential side effects that may arise during therapy with the device.
Step-by-step guide to modify the ramp time setting for comfort.
Instructions to activate the Ramp Down feature for comfortable pressure reduction.
Procedure to start the Ramp Down sequence for therapy.
To Next Page
