ResMed AirCurve 10 ST-A User Manual

English 21
Pneumatic flow path
1. Flow sensor
2. Blower
3. Pressure sensor
4. Mask
5. Air tubing
6. Water tub
7. Device
8. Inlet filter
Design life
Device, power supply unit:
5 years
Cleanable water tub: 2.5 years
Standard water tub, air tubing:
6 months
General
The patient is an intended operator.
Operator position
The device is designed to be operated within arm's length. An operator should position their line of sight within an angle of
30 degrees from a plane perpendicular to the screen.
Humidifier performance
Mask Pressure
cm H
2
O (hPa)
Nominal RH output %
Nominal system output AH
1
, BTPS
2
Setting 4
Setting 8
Setting 4
Setting 8
3
85
100
6
>10
4 85 100 6 >10
10
85
100
6
>10
20 85 90 6 >10
25
85
90
6
>10
30 85 90 6 >10
1
AH - Absolute Humidity in mg/L
2
BTPS - Body Temperature Pressure Saturated
Air tubing
Air tubing
Material
Length
Inner diameter
ClimateLineAir
Flexible plastic and electrical components
6'6" (2 m)
0.6" (15 mm)
ClimateLineAir Oxy
Flexible plastic and electrical components
6'4" (1.9 m)
0.75" (19 mm)
SlimLine
Flexible plastic
6' (1.8 m)
0.6" (15 mm)
Standard
Flexible plastic
6'6" (2 m)
0.75" (19 mm)
3 m
Flexible plastic
9'10" (3 m)
0.75" (19 mm)
Heated air tubing temperature cut-out: ≤ 106°F (≤ 41°C)
Notes:
• The manufacturer reserves the right to change these specifications without notice.
• The electrical connector end of the heated air tubing is only compatible with the air outlet at the device end and should
not be fitted to the mask.
• Do not use electrically conductive or antistatic air tubing.
• The temperature and relative humidity settings displayed are not measured values.

ResMed AirCurve 10 ST-A Specifications

General

Brand	ResMed
Model	AirCurve 10 ST-A
Category	Medical Equipment
Language	English