For control and service work, the operating mode of the
controller can be manually adjusted. For this purpose, select
the adjustment value HND1 / HND2. The following adjust-
ments can be carried out:
4.1.18 Operating mode
• HND1 / HND2
Operating mode
OFF : relay off
(flashing) +
AUTO : relay in automatic operation
ON : relay on
(flashing) +
HND1 / HND2:
Operating mode
Adjustment range:
OFF, AUTO, ON
Factory setting: AUTO
4.1.17 Pump speed control
A relative minimum pump speed is allocated to the output
R1 via the adjustment channel nMN.
Attention:
When loads which are not speed controlled (e.g.
valves)areused,thevaluemustbechangedto100%
in order to deactivate pump speed control.
nMN:
Pump speed control
Adjustment range:
30 ... 100
Factory setting: 30
(PG 67.30 and PG 69.30)
4.1.19 Language
In this channel, different languages are available.
• dE : German
• En : English
• It : Italiano
• Fr : French
LANG:
Language choice
Adjustment range:
dE, En, It, Fr
Factory setting: En
To Next Page
Loading...
Need help?
General
