30 31
Direct audio/programming Integrated FM
8.6.3 FM integrated with battery door
Your hearing care professional can replace the standard battery door with a DAI click-on adaptor or FM
click-on receiver.
8.7 Flight mode (optional)
i
WARNING: When boarding a flight or entering an area where RF transmitters are prohibited, wire-
less functionality must be deactivated.
Your ReSound LiNX 3D hearing aid allows you to control it from your smart phone or ReSound Unite
TM
Remote Control. However, in some areas you are requested to turn o wireless communication.
Follow these steps to turn o wireless mode:
1. For each hearing aid, open and close (open-close, open-close, open-close) the battery door three
times within a 10-second period.
2. Double-dings for ten seconds ( etc.) indicate that your hearing aid is in Flight mode.
Follow these steps to activate wireless mode:
1. For each hearing aid, open and close the battery door once.
2. Your hearing aids are in wireless mode after 10 seconds.
i
NOTE: Both hearing aids must be set in Flight mode - even with synchronisation enabled.
NOTE: It is important to wait an additional 15 seconds after wireless function resumes before
opening and closing the battery door again for any reason. Flight mode will resume if you open
and close the battery door during this 15-second window.
Your hearing care professional can replace the standard battery door with a DAI click-on adaptor or FM
click-on receiver
To Next Page
Loading...
