Respironics EverGo - Charging the Battery(s) with AC Power Supply

10
EverGo User Manual
Charging the Battery(s) with AC Power Supply
Important: e first time you charge the battery(s), be sure to charge it fully. Do
not use the DC power cord to do so; instead use AC power.
Note: e battery(s) will begin charging whenever you connect the device to an
AC outlet, even if you’re using it.
Tochargethebattery(s)usingtheACPowerCordprovidedwithyoursystem,
followthesesteps.
1. ConnecttheoutputcableoftheACPowerSupplytotheEverGo
powerinlet.
2. ConnecttheconnectoroftheACPowerCordintotheACpower
supply.
3. ConnecttheplugoftheACPowerCordintoanACoutletinstalled
to meet national or regional electrical code.
Figure 6. Connecting the power cord to the connector located under the Velcro flap.
A typical battery charging screen is shown on the right
Note: As soon as you connect the device to an energized AC power
source, the light on the AC Power Supply will light up and the cooling
fan will come on. is is normal. e fan will run the entire time it is
charging to keep the battery(s) cool.
4. Whenchargingiscomplete(thistakesaminimumoffourhours
forrstuse),disconnecttheACPowerSupplyandstoreitwiththe
ACPowerCordforfutureuse.
Note: Replacement and spare batteries are available separately. For
information, contact your homecare provider or see the EverGo web site
at www.evergo.respironics.com
VER 1.0.0.0