Respironics EverGo - OPERATING THE EVERGO DEVICE

11
EverGo User Manual
Note: An optional EverGo Smart Battery Charger/Recalibrator (sold
separately) is available for your system. For more information, contact
your home care provider.
op e r a T I n G T h e ev e r Go de v I C e
Warning: Do not use the device without one battery installed and operating.
• Torunthedeviceonbatterypower,makesurethebatteryis
properlyinsertedandsucientlycharged.(ebattery(s)shouldbe
fullychargedthersttimeyouuseit.)
• TorunthedeviceusingACpower,makesureyouhaveonebattery
installed.Followthesesteps:
1. ConnecttheoutputcableoftheACPowerSupplytothe
EverGopowerinlet.
2. ConnecttheconnectoroftheACPowerCordintotheAC
powersupply.
3. ConnecttheplugoftheACPowerCordintoanACoutlet
installed to meet national or regional electrical code.
Note: e AC Power Supply is equipped with a green light, which
illuminates when it is connected to an energized AC power source.
• TorunthedeviceusingDCpowerfromanautomobileorother
motorizedvehicle,makesureyouhaveonebatteryinstalled.
StartthevehicleandconnectoneendoftheDCPowerCordto
thedevice’spowerinletandtheotherendintothevehicle’sDC
electrical outlet.
Caution: If you operate the EverGo system using the DC power cord
while the vehicle engine is turned off, you could inadvertently drain
the vehicle’s battery.