Need help?Do you have a question about the Retrax IX Series and is the answer not in the manual?
General| Brand | Retrax |
|---|---|
| Model | IX Series |
| Category | Automobile Accessories |
| Language | English |
Assemble the rail end caps by inserting bolts and locknuts.
Assemble latch stops by inserting bolts and locknuts.
Assemble clamps by inserting set screws and bolts, or bolts, washers, and spacers for GM models.
Place canister assembly on rails, align rails, and insert fasteners.
Slide assembled latch stops into rail openings and tighten fasteners.
Attach rail end caps and position the cover with a 1/8" gap to the tailgate.
Position latch stops flush with end caps and tighten, ensuring symmetry between rails.
Place clamps in channel near latch stops and tighten bolts.
Align aluminum rails straight and tighten nylon set screws on clamps.
Ensure rails are parallel by measuring and adjusting clamp positions.
Insert drain tubes into canister holes and secure them.
Lists items and conditions excluded from the product warranty.
Details actions or circumstances that will invalidate the product warranty.
Outlines general terms, conditions, and limitations of the warranty policy.
To Next Page
