retrospec
ASSEMBLY INSTRUCTIONS
HARPER PLUS
HARPER 7 PLUS
TOOLS
We supply: 2 Allen Wrenches (5mm, & 6mm), a 10-function multi-tool.
You supply: Scissors or diagonal cutters, Phillips Screwdriver, 15mm open end wrench or adjustable wrench.
STEP 1: UNPACKING YOUR BIKE
1 - Cut the shipping straps on the outside of the box.
PLEASE KEEP THESE INSTRUCTIONS FOR
FUTURE USE & REFERENCE. DO NOT DISCARD.
WARNING: Serious injuries and even death can
occur if the proper safety precautions are not followed.
2 -Remove the box staples from the box top as these are sharp and can cut you as you access the bike. Open up the cardboard flaps and lift it out of its box.
3 -Rotate the fork so that it is facing forward of the bike. (Fig. 1) Place the bike on the ground, so it's standing upright on the fork dropouts and rear tire.
4 -Carefully cut all of the packing zip ties.
5 -Separate the front wheel from the bike by carefully slipping it away from the crank arm, which is resting within the spokes.
6 -Remove the accessory box and set it aside.
7 - Examine your new bike for any visible damage that may have occurred during shipping.
NOTE: For tightening all fasteners, please refer to Appendix D in the back of your owner's manual for all fastener torque specifications.
STEP 2: SADDLE
I - Remove the plastic shipping plug from the top of the seat tube. (Fig. 2)
2 - Use the included Allen wrench to loosen the seat clamp at the top of the seat tube.
3 -RECOMMENDED: Apply a thin layer of grease to the end of the seat post.
4 - Insert the seat with the seat post into the seat tube of the frame to at least the minimum insertion line on the shaft of the seat post.
WARNING! The minimum insertion line must NOT show above the seat tube. (Fig. 3)
5 - Using the Allen wrench, tighten the seat clamp once it is at the correct height.
NOTE: You can make the final adjustment to the height of the seat as needed after the bike is assembled.
WARNING! Using the bike with the minimum insertion line on the lower portion of the seat post showing above the frame could result in a
failure of the seat post and/or the frame causing a loss of control with potential injury to rider. Such failures are not covered by warranty as it
is improper use of the product. (Fig. 3)
STEP 3: HANDLEBARS
1 - Make sure that the handlebar stem and fork are facing towards the front of the bike.
Remove the four face plate bolts from the front of the handlebar stem.
2 - Remove the face plate and place the handlebars in the stem, making sure the handlebars are centered.
3 - Replace the face plate and insert each of the four bolts tightening each a little bit at a time to ensure even pressure on all four corners
using a cross pattern (Fig. 4).
NOTE: You'll be able to adjust the angle of the handlebars by loosening the bolts and re-adjusting the bar.
Plastic shipping
plug
Stem
Front
Min insert
025.4
Stem
Front
Clamp
1
To Next Page
Need help?
General
