Rev Electrix Cellpro 10XP

To Next Page

To Previous Page

2. When charging two packs simultaneously, connect the discharge wires into the banana jacks as shown

below.

Main Page

Table of Contents2
Description3
Features3
Precautions5
Parts5
Charger Terminology6
Pack Terminology and Configurations7
- REVOLECTRIX Cellpro Branded 5S Battery Packs7
- REVOLECTRIX Cellpro Branded 2S, 3S, and 4S Battery Packs7
- REVOLECTRIX Cellpro Branded 6S-9S Battery Packs8
Understanding the Cellpro 10XP Charger9
- Auto Charging Vs. Manual Current Settings9
- Power and Charging Speed9
- About Factory Presets11
- Power Management Feature11
Connecting Packs to the Charger12
- General Information12
- Connecting Non-Cellpro Packs12
- Connecting One 1S to 10S REVOLECTRIX Cellpro Pack13
- Connecting Two 1S to 5S Cellpro Packs13
Applying Power to the Charger15
- Introduction to Presets15
Operating the Charger16
- Overview of Button Operations16
Performing Common Tasks17
- Selecting a Preset17
- Changing a Preset17
- Charging a Pack or Packs19
- Options Menu Explained20
- Alternate Charging Modes23
Using the Charge Control Software24
- Installing the Charge Control Software24
- Launching the Charge Control Software24
- Connecting the Charger to Your Computer24
- Monitoring Charging Operations24
- Limiting Charger Input Current25
- Defining Presets25
- Setting Charger Options26
- Recording Charge Data26
- Updating Charger Firmware27
Balance Connector Wiring28
- When Using FMA WIRING Mode (Factory Default Setting)28
- When Using XH/EH WIRING Mode30
Estimating Performance Factors32
- Collect Data32
- Calculate Performance Factors32
- Evaluate Results32
Specifications33
Quick Start for the Cellpro 10XP Charger34
Troubleshooting35
Support Options37
REVOLECTRIX Limited Warranty38

Rev Electrix Cellpro 10XP - Page 14

Table of Contents