Connecting
one
1s to 10s REVOLECTRIX Cellpro pack
1.
How you connect the Cellpro pack’s balance connector(s) to the charger depends on the pack’s
configuration. Use the photos in the section “Pack terminology and configurations” above, then find
the configurations in the diagrams below and connect as shown in that diagram.
2. When charging a single pack, plug the discharge wires into the outermost banana jacks.
Connecting
two
1s to 5s Cellpro packs
1. How you connect the Cellpro packs’ balance connectors to the charger depends on the packs’
configurations. Use the photos in the section “Pack terminology and configurations” above, then find
the configurations in the diagrams below and connect as shown in that diagram.
To Next Page
Loading...