Reverso FPS-210 - User Manual

Other manuals for Reverso FPS-210

Manual16 pages

Questions and Answers

J
jbrowningAug 8, 2025
What to do if my Reverso FPS-210 has low or no flow?
- T
  Thomas GonzalesAug 8, 2025
  If your Reverso Control Unit experiences low or no flow, consider the following potential solutions: * Check if the pump is worn or not running. * Ensure the pump and filter are primed. * Verify the fuel supply or discharge line isn't blocked; check the alarm. * Confirm the lift isn't too high. * Inspect for air leaks in the fuel supply to the pump. * Ensure the inlet or outlet valve is open; check the solenoid valve. * Verify the foot (check) valve isn't installed backward. * Look for air leaks at the inlet. * Check for improperly installed or dimensioned piping. * Service the fuel water separator to see if it's clogged.
E
Emily PowellAug 13, 2025
Why does the motor on my Reverso FPS-210 Control Unit not turn or turn intermittently?
- J
  John BarberAug 13, 2025
  If the motor on your Reverso Control Unit does not turn or turns intermittently, here are some things to check: 1. Ensure control power is available. 2. Check for a tripped circuit breaker on the control board. 3. The pump might have failed and seized. 4. There could be a motor failure. 5. Verify the service switch is in the ON position.
S
smithmelindaAug 17, 2025
How to fix fuel leaking from the Reverso Control Unit pump?
- D
  Dale CookAug 17, 2025
  If the pump of your Reverso Control Unit is leaking fuel, consider the following potential causes and solutions: * Check for loose pump plumbing fittings. * The pump shaft seal might be worn. * Excessive heat from an overhead storage tank could be a factor. * Worn pump o-rings or seals may be the cause.
R
Rebecca BrewerAug 22, 2025
Why is my Reverso FPS-210 Control Unit making noisy operation?
- C
  Carolyn HowardAug 22, 2025
  If your Reverso Control Unit is operating noisily, it could be due to: * Insufficient fuel supply. Ensure there is enough fuel. * Air in the suction hose. Check that the hose is submerged in the fuel or check for leaks.
B
Brenda PowellAug 28, 2025
What causes rapid pump wear in a Reverso FPS-210 Control Unit?
- L
  Laura NewtonAug 28, 2025
  Rapid pump wear in your Reverso Control Unit could be caused by the pump running dry. Ensure a sufficient fuel supply to prevent this.
J
Joel HallSep 2, 2025
What to check in case of electrical issues with Reverso FPS-210 Control Unit?
- D
  david62Sep 2, 2025
  In case of electrical issues with your Reverso Control Unit, verify the voltage and breaker.