Revitive CIRCULATION BOOSTER ESSENTIAL - Safety Precautions; Adverse Reactions

18
19
f Remove the plastic liner from the Body Pads, by
peeling it o carefully. Replace the Body Pads onto
the plastic liner aer use.
g Press the Body Pads on the area you wish to apply
electrical stimulation to, as shown on page16, gently
pressing the adhesive side against the skin.
h Press the power button on the Revitive.
You will hear a beep and the display lights will read
30 minutes.
To turn o the device at any time during
operation, press the power button.
i Press the (+) Intensity Control, one time, to
start stimulation.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
j Ensure you familiarize yourself with the feeling of
Electrical Muscle Stimulation (EMS). Use on a low
intensity for 30 minutes once per day for a
few days.
Instructions for use
R
R
R
R
R
R
R
R
Set the intensity at a level you can feel the stimulation
or see your muscles twitch.
It is normal to feel tingling or varying sensations in
your muscles you are treating.
k Aer a few days of familiarization, use a higher intensity
that provides you with strong but comfortable muscle
contractions.
You can set the intensity between 1-50.
Please note that the intensity required may vary from
day to day.
l The Time display will start to count down in
minutes as Revitive cycles through its program.
m When Revitive times out, the Time display reads
00 and you will hear three beeps, and the device will
switch itself o automatically.
If you feel pain or discomfort:
• Lower the intensity of the Body Pads using the (–) Intensity
Control.
• You can also choose to stop therapy before the end of the 30 minute
session to avoid skin irritation. You can do this by pressing the
power button.
EN
5827_IFU04_17963935.indd 18-19
5827_IFU04_17963935.indd 18-19
09/04/2021 13:23
09/04/2021 13:23