What to do if my Revitive CIRCULATION BOOSTER ESSENTIAL Fitness Equipment has no power?
If your Revitive Fitness Equipment shows no power or lights when switched on, first ensure the AC adapter is properly connected to both the device and a working electrical socket. Verify that the socket is switched on. If the issue persists, contact your authorized dealer.
How to increase intensity on Revitive Personal Care Product?
If you can see the lights on the LED display but can't feel the electrical stimulation through the foot-pads of your Revitive Personal Care Product, the intensity level might be too low. Gradually increase the intensity level towards 50 until you feel the stimulation. You may need to increase the intensity as you get used to the therapy. The goal is to find a comfortable setting, not necessarily to reach 50.
What to do if I can't feel the stimulation on my Revitive Personal Care Product?
If you can see the lights on the LED display but can't feel the electrical stimulation through the foot-pads of your Revitive Personal Care Product, make sure both bare feet are placed on the foot-pads simultaneously. Increase the intensity gradually, up to a maximum of 50, until you feel the stimulation.
Why can't I feel the electrical stimulation on my Revitive Personal Care Product even though it's on?
If you can see the lights on the LED display but can't feel the electrical stimulation through the foot-pads of your Revitive Personal Care Product, your feet might be too dry. Moisturize the soles of your feet to improve conductivity and stimulation, then try again. You may also need to increase the intensity level.
What to do if Revitive Personal Care Product is on but I don't feel anything?
If you can see the lights on the LED display but can't feel the electrical stimulation through the foot-pads of your Revitive Personal Care Product, ensure that the electrode cord is disconnected. The foot-pads will not work while the electrode cord is plugged in.
Why does my Revitive Personal Care Product feel weak?
If you can see the lights on the LED display but can't feel the electrical stimulation through the foot-pads of your Revitive Personal Care Product, you may be dehydrated. Drink plenty of water before and after using the device. Water helps conduct electricity, and if your body is less hydrated (below 60%), the stimulation may be less effective. Staying well-hydrated is important.
Why are my legs aching after using Revitive Personal Care Product?
If your legs are aching after treatment with the Revitive Personal Care Product, it may be because the intensity was set too high, overworking your muscles. Allow adequate time for your muscles to recover after each session, similar to after vigorous exercise. During your next session, begin with a lower intensity setting where you can comfortably feel the mild electrical stimulation, and reduce the duration until your muscles adjust to the stimulation.
How to troubleshoot Revitive Personal Care Product no power?
If there is no power or lights to your Revitive Personal Care Product when switched on, check that the AC adapter is properly plugged into both the electrical socket and the device, and that the electrical socket is switched on.
Button to switch the device on and off.
The main surfaces for foot stimulation.
Interface showing time, intensity, and adjustment controls.
Critical warnings and precautions for safe use.
Advice and precautions to avoid minor issues or discomfort.
General safety guidelines for operating the device.
Potential negative effects and when to seek medical advice.
Intended uses when applying stimulation via foot-pads.
Intended uses when applying stimulation via body pads.
Step-by-step guide to prepare the Revitive device for initial use.
Instructions on how to correctly use the Revitive foot-pads.
Guidance on applying electrical stimulation using body pads.
Procedures for cleaning and storing the Revitive device.
Information on when and how to replace the electrode body pads.
Diagnosing issues when no electrical stimulation is felt through foot-pads.
Resolving problems related to the device not switching on.
Addressing muscle discomfort or fatigue after using Revitive.
Key technical details including model, power, and dimensions.
Electrical Muscle Stimulation output parameters.
Explanation of safety and compliance symbols used in the manual.
Conditions under which the warranty is not applicable.
General| Technology | Electrical Muscle Stimulation (EMS) |
|---|---|
| Remote Control | Yes |
| IsoRocker System | Yes |
| Product Type | Muscle Stimulator |
| Power Source | Mains Adapter |
| Electrode Pads | 2 |
| Weight | 1.5 kg |
To Next Page
