What to do if my RevoAce Grill has flare-ups?
If your RevoAce Grill experiences flare-ups, it's likely due to: * Grease buildup: Remove and clean all grill parts. * Excess fat in meat: Trim fat from meat before grilling. * Excessive cooking temperature: Adjust to a lower cooking temperature.
Why does the flame keep going out on my RevoAce Grill?
The flame on your RevoAce Grill might be going out due to: * High or gusting winds: Do not use the grill in high winds. * Low LP Gas: Exchange, refill, or replace the LP gas tank. * Overfilling prevention device activation.
Why is there a sudden drop in gas flow on my RevoAce GBC1748WS Grill?
A sudden drop in gas flow or reduced flame height in your RevoAce Grill may be due to: * LP: running out of gas (exchange, refill, or replace LP gas tank). * NG: No main line pressure (call your natural gas provider to inspect the natural gas line). * LP: The overfilling prevention device may have been activated. To reset it: 1. Turn control knobs to “ OFF”. 2. Wait 30 seconds and light grill. 3. If flames are still too low, reset the overfilling prevention device: a. Turn control knob(s) “ OFF” b. Turn LP gas tank valve to “CLOSED” c. Disconnect regulator d. Turn control knobs to (HIGH) e. Wait 1 minute f. Turn control knobs to “ OFF” g. Reconnect regulator and leak check connections, being careful not to fully open valve h. Light grill.
Why is the flame yellow or orange on my RevoAce GBC1748WS Grill?
A yellow or orange flame on your RevoAce Grill could be caused by: * New burner residual manufacturing oils: Burn the grill for 15 minutes on (HIGH) with the lid closed. * Spider webs or insect nest in venturi: Clean the venturi. * Food residue, grease, etc. on burners: Clean the burner. * Poor alignment of valve to burner/venturi tube: Ensure the burner/venturi tube is properly engaged with the valve.
What causes a persistent grease fire in my RevoAce Grill?
A persistent grease fire in your RevoAce Grill is likely caused by grease trapped by food buildup around the burner system. To resolve this: 1. Turn control knobs to “ OFF”. 2. Turn the LP gas tank valve to “CLOSED” (LP) or the natural gas main valve to “OFF” (NG). 3. Leave the lid in the closed position and let the fire burn out. 4. After the grill cools, remove and clean all parts.
Why does my RevoAce GBC1748WS have an irregular flame pattern?
An irregular flame pattern on your RevoAce Grill, where the flame does not run the full length of the burner, is likely because the burner ports are clogged or blocked. Clean the burner ports to resolve this issue.
What causes flashback in my RevoAce GBC1748WS burner tubes?
Flashback (fire in the burner tubes) in your RevoAce Grill is caused by blocked burners and/or burner/venturi tubes. Clean the burners and/or burner/venturi tube(s) to resolve this.
Why is the inside of my RevoAce Grill lid peeling?
The peeling on the inside of your RevoAce Grill lid is likely due to grease buildup that has turned to carbon and is flaking off. Thoroughly clean the lid.
How to fix RevoAce GBC1748WS Grill igniter not working?
If the burner on your RevoAce Grill won't light using the igniter, there are several potential causes: * The LP gas tank valve might be closed, or the NG main valve might be closed. For LP, ensure the regulator is securely attached to the LP gas tank and turn the tank valve to “OPEN”. For NG, ensure the regulator and NG main line are securely attached and turn the NG main valve to “ON”. * The LP gas tank could be low or empty, in which case you should exchange, refill, or replace it. * There could be an LP gas or NG leak. If so, turn the gas tank valve to “CLOSED” (LP) or the natural gas main valve to “OFF” (NG), wait 5 minutes, and then follow the leak checking procedure. * The battery may need to be changed; replace the “AA” battery. * Wires or the electrode might be covered w...
Why won't my RevoAce Grill burner light with a match?
If your RevoAce Grill burner won't light with a match, consider these possibilities: * **No gas flow:** For LP, check if the LP gas tank is empty and exchange, refill, or replace it if needed. For NG, make sure the regulator and NG main line are securely attached, then turn NG main valve to “OPEN”. * **Low or empty LP gas tank:** Exchange, refill, or replace the LP gas tank. * **LP gas/NG leak:** Turn the LP gas tank valve to “CLOSED” (LP) or the natural gas main valve to “OFF” (NG), wait 5 minutes, and then follow the leak checking procedure. * **Coupling nut and regulator not fully connected:** Turn the coupling nut about one-half to three quarters additional turn until solid stop. Tighten by hand only - do NOT use tools. * **Obstruction of gas flow:** Clear burner tubes and c...
Instructions for igniting and operating the primary burners of the grill.
Steps for preparing the grill for its initial cooking session.
Procedure for safely shutting down the grill after use.
Methods to manage and prevent excessive grill flare-ups.
Guidance on using the side burner for cooking.
Essential checks and cleaning steps before operating the grill.
Methods for cleaning the exterior surfaces of the grill.
Detailed steps for cleaning the main burner assembly.
Instructions for cleaning the side burner components.
This document is an owner's manual for an Outdoor LP Gas Barbecue Grill, specifically models GBC1748WS and GBC1748WPF. It provides comprehensive instructions for assembly, operation, maintenance, and troubleshooting, emphasizing safety throughout.
The device is an outdoor LP (Liquid Propane) gas barbecue grill designed for residential use. Its primary function is to cook food outdoors using propane gas as fuel. It features multiple main burners and a side burner, allowing for versatile cooking options. The grill is equipped with a lid handle, temperature gauge, warming rack, cooking grids, heat plates, and a grease management system (grease cup and tray). It is also convertible to natural gas (NG) with a separate conversion kit (model VFK1702W).
To Next Page
General
