REVV | GENERATOR 120 MK3
3
TABLE OF
CONTENTS
P4 Warranty
P5 Safety Instructions & Warnings
P6 Set up & Power up
FRONT PANEL LAYOUT
P7/10
1 Input
2 Channel One (Clean)
3 Channel Two (Crunch)
4 Channel Three (Purple Gain)
5 Channel Four (Red Gain)
6 Master Volume Control
7 Depth & Presence
Function Controls
8 Reverb Switch
9 Gate Switch
10 Store Switch
11 Pre-Post Switch
12 Headphone Jack
13 Headphone/XLR Level Control
14 Virtual Cabinet Switch
15 Bluetooth Window
16 Standby & Power Switches
BACK PANEL
P11/13
17 Main Power Connection
18 Main & HT Fuses
19 Bias Test Points
20 Power Tube Fault Fuses
21 XLR Output and Ground Lift
21.1 XLR Output Connectors
22 USB Connector
23 Reverb Level Control
24 Gate Threshold Control
25 Wattage Switch
26 Internal Load Switch
27 FX Loop Send and Return Jacks
28 Cabinet Lighting
29 Foot Switch Connection
30 MIDI Connections
31 Impedance & Speaker Jack
TUBES AND BIAS
P14/15
32 Power Tubes
33 Power Tube Sockets
34 Preamp Tubes
35 Power Tube Bias
36 Setting The Bias
37 Bias Chart
MIDI
P16/18
38 Setup
39 OMNI Mode
40 MIDI Channel Setting
41 MIDI Program Change
42 MIDI Controllable Functions
43 Continuous Controller (CC)
TORPEDO REMOTE/LOAD
P19
44 Bluetooth Connection
45 Troubleshooting
46 Internal Reactive Load
SETTINGS & SAVING CABINETS
P20/21
47 Front Panel/Cab Lighting On/O
48 Saving Global/Masters
49 Saving A Digital Cab To A Bank
50 Saving A Digital Cab To A Channel
51 Disable/Enable Speaker Cab
52 Factory Reset
FOOT CONTROLLER
P22/23
53 Hook up
54 Control Mode
55 Preset Mode
56 To Save A Preset To A Bank
57 Foot Controller Reset
58 Foot Controller Mute
To Next Page
Loading...
