REPLACING THE FUSE
The bike is equipped with a 30-amp fuse to protect system in the
event of electrical shorts. When a short or overload in the system
occurs, the fuse activates which will protect the wiring and help to
avoid possible fire.
Possible situations that can result in a blown fuse can be:
1. A worn or pinched wire in the system that causes a short.
2. Moisture in the system.
3. Overloaded electrical system.
In the event of a burned-out fuse, your Revvi will not work when
you turn it on and the indicator lights will not light up. To check and
replace the fuse, follow the steps on the following page:
1. Open the plastic battery case by removing both knob screws
(on the front and back of the battery case) and pulling the right
side panel off.
2. Locate the black rubber fuse housing, in the wiring above the
battery.
3. Open the rubber flip top lid and carefully pull out the fuse.
4. Inspect the fuse and replace if necessary.
5. Re-assemble the fuse holder and the body case, making sure it
is clean and dry inside and that all the wring is safely tucked
inside. Watch carefully for pinched wires.
NOTE: IF THE FUSE CONTINUES TO BURN OUT YOU HAVE
ENCOUNTERED AN ELECTRICAL PROBLEM. PLEASE CONTACT
SUPPLIER FOR SUPPORT.
To Next Page
Loading...