ADJUSTING THE BRAKE
This bike is equipped with a rear disc brake system.
You should check the brake and make sure it is working properly
before each ride. The brake should feel firm when the lever is
pulled. You should not be able to pull the brake lever all the way
back to where it touches the hand grip. If you can squeeze the
brake lever all the way to the hand grip. Your brake needs
adjusting. There are two options to adjust the brakes:
OPTION 1: Adjust using the barrel roller.
1. Loosen the set ring on the barrel adjuster.
2. Screw the barrel adjuster out a few turns and then check the
tension in the lever.
3. If it feels right, re-tighten the set ring.
4. If not, repeat step 2 until the brake feels right and then tighten
the set ring nut.
To Next Page
Loading...