CHECK THE TIRE PRESSURE
It is very important to check the tire pressure before every.
Running on low tire pressure can create a dangerous situation as
the bike will not handle properly and could cause the rider to lose
control. To check the tire pressure, locate the air valves inside the
rims on each wheel and remove the black plastic cap. Using a tire
gauge, check to make sure that there is a minimum of 15psi in each
tire, and no more than 30 psi of pressure in each tire.
REMOVING THE BATTERIES
The two batteries on your Revvi can be removed. To remove the
batteries, follow the steps outlined below:
1. Ensure the bike is switched off.
2. Open the plastic battery case by removing both knob screws
(on the front and back of the case) and pulling the right side
panel off.
3. Undo the metal bracket that holds the batteries in place. One
fixing on each side.
4. Unplug the plastic connector between the loom and the
batteries.
5. Once the batteries are disconnected carefully remove them
from the battery tray.
WARNING THE REVVI USES LEAD ACID BATTERIES WHICH MUST BE
DISPOSED OF PROPERLY. DROP THEM OFF AT ANY LOCATION THAT
DESPOSES OF AUTOMOTIVE BATTERIES. DO NOT DISPOSE OF THEM
IN YOUR HOUSEHOLD TRASH AND NEVER BURN A LEAD ACID
BATTERY AS AN EXPLOSION COULD OCCUR
WARNING IF A BATTERY LEAK OCCURS, AVOID CONTACT WITH THE
ACID AS IT IS CORROSIVE, POISONOUS AND DANGEROUS. IF ACID
To Next Page
Loading...