Revvi ABT-E250 - 2-Stage Safety Speed Limiter

2-Stage Safety Speed Limiter
The Revvi is equipped with a special switch that reduces the speed
to accommodate younger, smaller riders. The switch is located
inside the battery case, under the battery in a hard to reach spot to
limit access by inquisitive smaller children.
NOTE: The 2-stage safety speed limiter switch is set at the factory
to the slower speed setting. To switch from slow speed to regular
speed, or vice-versa, follow the steps below.
1. Lift the front of the bikes up or lean the bike on its side.
2. These is a small hole in the bottom of the plastic covers that
protect the batteries. Reach through the hole with your finger
and flick the switch from “I" (slow speed) to “O” (fast speed).
3. Your Revvi is now set to its fastest setting. To return the bike to
the slow speed setting follow these steps but flick the switch
back to "I".