28
Adjusting the front shock
To adjust the suspension damper on the steering fork, please proceed as described for the rear axle. The setting on the steering fork can be selected
individually and does not have to match the setting on the rear axle.
Adjusting the rear dampers
To adjust, turn the adjusting screw in one of the two directions as far as it will go. Then turn the adjusting screw step by step in the opposite direction until you
have reached the desired level - counting the steps! Repeat the adjustment for the other rear axle damper.
Adaptive chassis
As an option, your vehicle can be equipped with an adaptive chassis. To adapt the suspension to the load situation and driving style, proceed as follows. Each
chassis damper can be adjusted in stages over 32 steps in the direction of "softer" or "harder" by turning the adjustment screw.
Switch for the hazard warning lights
In the event of a vehicle breakdown or to indicate a hazard, e.g., the end of a traffic jam, the vehicle is equipped with hazard warning lights.
Switching on the hazard warning lights - with radio key
To switch on the hazard warning lights, you must first switch on the ignition. Then press the red hazard warning light switch on the left switch. After the hazard
warning lights have been switched on, the ignition can be switched off again. The hazard warning lights remain activated.
Functions and settings
To Next Page
Loading...
