Electrical / Fuses
The Fuse boxes / control panel is located behind the driver seat. Blown fuses must be replaced. Reserve fuses are in the free slots of the control panel. Please
proceed as follows when replacing a defective fuse:
Switch off the ignition and the affected electrical load.
• Determine which fuse belongs to the failed electrical consumer (see right side).
• Remove the affected fuse
• If the fuse has blown (can be seen by the melted metal strip), replace it with a fuse of the same rating
More about the electrical system and fuses on the next page
Lack of braking power
Lack of engine power
If the engine power fails while driving, please park the vehicle as soon as possible in a safe place (drive to the next free parking space or parking lot).
45
If misfired, the catalytic converter of your vehicle will be destroyed. Park the vehicle in a safe place and contact the nearest rewaco dealer.
If you notice a loss of braking force or a change in braking behavior while driving, stop the vehicle at moderate speed and park it in a safe place. Have the
brake system checked at a rewaco dealer..
Faults and malfunctions
To Next Page
Loading...
