40
Checking the brake fluid
The brake fluid reservoir is located below the dummy tank. The condition of the brake fluid is also checked as part of an inspection service.
The brake fluid absorbs moisture from the ambient air over time. Excessive moisture content in the fluid can cause damage to the brake system. Therefore, you
should have the brake fluid checked regularly by a rewaco partner company.
Do not open the battery! Battery acid is corrosive and must not get into the eyes, on the skin or on clothing.
If the brake indicator light comes on, park the vehicle in a safe place and contact a rewaco partner.
Charging and receiving the battery via an optional charger
If your trike is stationary for a longer period and the battery is discharged, you can charge the trike's battery with an optionally available charger. By folding up the
driver's seat, you can reach the battery terminals of the vehicle battery installed under the driver's seat. The optional charger is connected by connecting the two-
pin connector to the plug on the positive and negative terminals. The battery is located under the driver's seat. To open the driver's seat, follow the instructions on
page 31.
Cleaning of plastic and aluminum parts
If standard washing is not sufficient, plastic and imitation leather should only be treated with special plastic cleaners. Aluminum parts should be cleaned and
preserved regularly.
Cleaning and care of the body
Frequent washing maintains the value of your vehicle.
Treat the body and paint from time to time with preservatives and polish from time to time.
Tire pressure and wear
Too high or too low tire pressure not only affects the safety of the trike, but also its wear. The tire pressure should therefore be checked twice a months or before
and after a long ride. (See page 46)
Brake pad wear
The wear of the brake pads is largely dependent on the operating conditions and the driving style. Maintenance of the brake system must be performed at a
specialist workshop in accordance with the prescribed inspection and maintenance intervals. Read the coolant level at the coolant expansion tank. When the engine
is cold, it must be at the level of the tank seam. When the engine is warm, it may also be slightly above the tank seam.
No warranty is given for the application and removal of stickers, trims and similar materials.
Maintenance and care
To Next Page
Loading...
