50
Switch on ignition and start vehicle with factory key
1. Open the driver's seat with the hand-held remote control. If you do not have access to the remote control, you will find a wire loop under the trike on the right
in the direction of travel. Pull it firmly and the seat will unlock. This is an emergency release only. Not suitable for daily use.
2. Insert the service key into the lock next to the tank.
3. Turn the service key and press the start button, the display lights up. The trike can now be started. Make sure that the kill switch is set to ON.
4. For standard use, it should be removed from the lock to prevent unauthorized starting of the trike and stored safely.
• Put the key in the OFF position.
• Turn the key to the right = ignition ON
• Turn the key from pos. ON to the left = ignition OFF
Switching off the engine and switching off the ignition with the factory key
• If you set the knob to position, the motor will be
switched off!
• Briefly confirm the start button without pressing the brake pedal, then the ignition is switched off and the LCD instrument switches off. Ignition is
OFF!
• Set the knob back to position , the motor remains switched off!
If you start the trike with the service key, make sure that it is switched off again after using the trike. Otherwise, the battery may discharge unnoticed. The
service key is only to be used in exceptional cases such as servicing.
Faults and malfunctions
To Next Page
Loading...
