7
Batteries
An Alkaline Battery Pack is standard
equipment with the PJ2+ COM. Alkaline
batteries are a good power source for a
backup radio because they have excellent
storage life and no maintenance is
required. The Alkaline Battery Pack is
NOT rechargeable. The batteries must be
replaced. To replace the batteries, turn the
power OFF and then remove the battery
pack from the unit by holding the belt
clip (if installed) in the out position, and
then lift the latch mechanism found at
the bottom of the battery pack. Remove
the battery cover by pulling the thumb
latch in the direction of the arrow. Six 1.5
volt AA Alkaline batteries are required.
Energizer batteries are the recommended
battery for the PJ2+ COM. Results may
vary when using off brand batteries.
Replace the batteries by following the positive (+) and negative (-)
terminal markings inside the case. When the batteries are replaced,
replace the battery cover and attach the battery pack to the radio.
To attach the battery pack, make sure the power is OFF. Slide the
battery pack onto the back of the and push in on the bottom until it
locks in place.
If the radio will not be used for a long period of time (six months or
more), please remove the batteries from the battery pack. This will help
prevent the batteries from corroding the battery pack.
Manual_final.indd 7 7/13/22 1:51 PM
To Next Page
Loading...
