0108ML00GBEN
2
INDEX
Page
1. General.......................................................................................................................................................2
2. Technical data .............................................................................................................................................3
3. Installing.....................................................................................................................................................5
4. Combustion, Air supply and flue system..........................................................................................................6
5. Gas connection............................................................................................................................................8
6. Electrical connection.....................................................................................................................................9
7. Commissioning, lighting and operation ............................................................................................................9
8. Maintenance..............................................................................................................................................10
9. Spare parts list...........................................................................................................................................15
10. Gas conversion .........................................................................................................................................16
11. Fault finding .............................................................................................................................................17
12. Health and Safety Statement ......................................................................................................................18
13. User instructions.......................................................................................................................................19
If optional equipment was ordered and supplied with this air heater, please refer to additional instructions for option(s).
SECTION 1. GENERAL
1.1 Before installation, check that the appliance as
described on the packaging label is in accordance
with the correct type and model as specified on the
data plate and complies with your customer order.
1.2 After unpacking the appliance, leave it fastened to
the wooden pallet until it has been suspended or until
just before base mounting. This affords protection to
the painted underside which is normally exposed to
view after installation.
1.3 Please read this document before commencing
installation.
1.4 These instructions are only valid for the country of
use indicated on the appliance i.e.: GB - IE. If these
symbols are not shown, it is necessary to obtain
appropriate technical instructions which will provide
information concerning the necessary modification of
the appliance for the conditions of use in the country
concerned. Such instructions may be obtained upon
request from your supplier.
1.5 Check that the local distribution conditions of
electricity supply, type of gas and pressure, and
adjustment of the appliance are compatible.
1.6 When installed in Great Britain the total installation
must comply with the requirements and
recommendations of British Standard BS 6230
1991. "Installation of Gas Fired Forced Convection
Air Heaters for Commercial and Industrial Space
Heating".
The Installation must also be in accordance with the
relevant requirements of "The Gas Safety (Installation
and Use regulations) and (Amendment Regulations
1990)" and The "Building" and "Electrical
Regulations" (in GB the IEE Regulations).
The requirements of the "Local Building Standards
Office", the premises "Insurance" undertaking and
the"Fire Office" must also be observed.
1.7 Unauthorized modification of this appliance or
departure from use in the manner for which it was
intended by the manufacturer or installation in a
manner contrary to these instructions, may constitute
a hazard and jeopardize all warranties. Deviations
should only be carried out after formal consent has
been obtained from the manufacturer.
1.8 Ensure the environment in which the air heater will be
installed will not create a hazard i.e. where excessive
(volatile) dust, flammable or corrosive substances
and/or vapours and combustible materials may be
present.
1.9 This appliance has been tested, and set according to
the data plate before leaving the factory.
To Next Page
Loading...
Need help?
General
