The Eagle Manual
10
• 6: move skew - pressing and holding the appropriate button will
manually move your dish in skew (Up arrow right side DOWN, Down
arrow left side DOWN
• 7: test dish - will move the dish in all axis for one complete cycle
• 8: temperature - will display current operating temperature of its
operating environment.
• 9: test azimuth - will automatically do a test of the azimuth sensor
• 10: test elevation - will automatically do a test of the elevation sensor
• 11: test skew - will automatically do a test of the skew sensor
• 12: exit - Selecting this option will take you back to main menu
NOTE: There is an "OVER TEMPERATURE" condition that will be displayed at the beginning of the
SEARCH function if the operating environment is in excess of 136°F. It will not prevent the SEARCH
routine but will warn of potential damaging heat conditions for the equipment within that operating
environment.
AFTER LOCKING ONTO THE PROPER SATELLITE:
The controller will remain ON for a few minutes and then automatically turn OFF.
AFTER STOWING:
The controller will automatically turn OFF
.
Updating and Maintaining Software
The software can be maintained by use of a USB Flash Drive.
•
Call RF Mogul for the software for your application. Make sure that it is placed in the "root
directory" and that no other .hex file is in that directory.
•
Insert your flash drive into your EAGLE RE-1 controller.
•
Turn power ON
•
Wait for the progress bar that will indicate that the software is being successfully loaded (usually
8 seconds).
•
Remove the flash drive and press SEARCH to implement acquisition.
To Next Page
Loading...
Need help?
General
