Copyright 2011-2012, RFXCOM
RFXtrx Version 2.12 page 6 / 20
6. RFXmngr test program
The RFXmngr program supports decoding of received data and allows you to transmit
commands.
After the connection the RFXmngr program transmits a Reset and Get Status command so that
it will know the RFXtrx type and configuration settings:
Transmitter protocols are always enabled but receiver protocols can be disabled. This is very
useful because the receiver will become more sensitive when protocols not used are disabled.
So select only the protocols to be used, click Set mode and on the Receiver tab click Save
Settings. Note that these settings are lost after a firmware update and need to be set again.
To Next Page
Loading...
