Need help?Do you have a question about the Rheem 18 and is the answer not in the manual?
General| Brand | Rheem |
|---|---|
| Model | 18 |
| Category | Water Heater |
| Language | English |
Details about the water heater model, its operation, and gas boosting for solar systems.
Information on mains water pressure, desired water temperature, and scald risk.
General safety warnings, electrical safety, and advice for going on holidays.
Covers general maintenance, servicing, frost protection, and draining procedures.
Introduces standard and deluxe controllers, their types, and basic functions.
Explains standard controller buttons, lights, display, and basic operation.
Details temperature settings, adjustment procedures, and controller limitations.
Details deluxe controller functions, voice prompts, and temperature adjustment.
Covers Bath Fill mode and related functions for deluxe controllers.
Guides users on resolving issues like no display on the controller or cold water from the tap.
Addresses problems with water being too hot, not hot enough, or fluctuating flow.
Explains how to interpret error codes and addresses concerns about high gas bills.
Specifies where to install the water heater, required clearances, and general installation standards.
Covers mains pressure, frost protection, pipe covers, and recess installation.
Details hot water delivery, scald risk, temperature limiting devices, and diagrams.
Provides dimensions, technical data, and specifications for the water heater models.
Specifies connection sizes for hot water, cold water, and gas inlet.
Details pipe work, valves, gas inlet, and specific connection procedures.
Covers electrical work requirements, power supply, and the heater's power consumption.
Explains the Ez-Link system for dual water heater control and required components.
Outlines installation principles, label placement, and controller requirements for dual units.
Step-by-step guide for connecting the Ez-Link cable between water heaters.
Introduces controller types (Standard/Deluxe), their functions, and suitable installation locations.
Covers installation steps for kitchen controllers, including components and base plate.
Details installation for bathroom controllers, including components and foam packing.
Explains the final steps to connect the installed controllers to the water heater.
Covers turning on the heater, gas inlet pressure testing, and initial checks.
Details procedures for checking and adjusting minimum and maximum burner gas pressures.
Explains how to check/adjust the factory preset outlet temperature settings.
Provides instructions on how to properly turn off the water heater.
To Next Page
