FIGURE 32
REMOVE THE MEMORY CARD WHEN REPLACING THE FURNACE CONTROL. THIS PHOTO SHOWS THE CORRECT WAY TO REMOVE THE MEMO-
RY CARD. DO NOT CUT THE TETHER.
For communicatinig systems as a final
confirmation of the correct shared data
the model number should be verified by
checking the furnace user menu under
the sub menu titled “Unit Info.” Make
sure that the model number displayed in
the menu matches the model number
on the rating label. (NOTE: Wild cards
will be shown in parenthesis. Example:
RGFLE/F)-06(E/N)MCKS.)
42
To Next Page
Loading...
Need help?
General