En-7
(3) Attach the intake grille.
Top holes (two sides)
Top hole (center)
Top hook (center)
Front panel
Indoor unit
Top hooks
(2 sides)
Front panel
Bearing
Mounting shaft
Intake grille
Intake grille
Knob
Wall hook bracket
Front panel
Push
[▲] mark
Screws
(6 position)
Push
Front panel
CAUTION
Install the front panel and Intake grille securely. If installation is imperfect, the front
panel or Intake grille may fall off and cause injury.
9. REMOTE CONTROLLER INSTALLATION
• Check that the indoor unit correctly receives the signal from the remote controller, then
install the remote controller holder.
CAUTION
Select the remote controller holder selection site by paying careful attention to the
following:
- Avoid places in direct sunlight.
- Select a place that will not be affected by the heat from a stove, etc.
9.1. Remote controller holder installation
Install the remote controller a maximum distance of 22 ft. (7 m) from the remote control
receiver. However, when installing the remote controller, check that it operates cor-
rectly.
I
nstall the remote controller holder to a wall, pillar, etc. with the tapping screw.
Remote controller holder fi xing
Remote controller
holder
Tapping
screw
(small)
Remote controller munting
Remote
controller
2
Push
1
Set
Latch-
(5) Fasten the drain hose to the outside wall, etc.
*Locally purchased
Pipe
Saddle*
Outside wall cap*
Sealer putty*
(Outdoors)
Wall
Overlap the insulation
Vinyl tape
Wrap with cloth tape
Cloth tape
Drain hose
Connection cable
Pipe
Drain hose
Drain hose
Connection pipe
Wall pipe Connection cable
Left piping For connection from the left rear
Pipe
Connection pipe
(heat insulation)
Indoor unit pipe
(heat insulation)
Bind the pipes together
so that there is no gap.
Check the following:
GOOD
Drain hose
Saddle
Lifted up Wave End in water
PROHIBITED
8. FRONT PANEL REMOVAL AND INSTALLATION
8.1. Intake grille removal
(1) Open the intake grille.
(2) Pull down the knob.
(3) Lift the intake grille upward, until the axle at the top of the intake grille is removed.
8.2. Intake grille installation
(1) The fi xing axle of the intake grille is installed on the Panel.
(2) Lay down the intake grille.
8.3. Front panel removal
(1) Remove intake grille (Reference the intake grille removal.)
(2) Remove 6 screws.
(3) The thumb is hung on the lower part as shown in the fi gure, and it pulls to the front,
pushing [▲] mark , and bottom hooks (2 position) is removed from wall hook bracket.
(4) Pull the front panel to the front, then raise it to remove.
8.4. Front panel installation
(1) First, fi t the lower part of the front panel, and insert top and bottom hooks. (3 top
sides)
(2) Attach the 6 screws.
9318739244_IM.indb 79318739244_IM.indb 7 2016/11/29 下午 10:40:182016/11/29 下午 10:40:18
To Next Page
Loading...
