6 / 15
■Installation Guideline
The installation must be in compliance with the National Electrical Code, your local electrical and
plumbing codes.
1. Make sure the appliance is intact, and the fittings are complete.
2. Check valve is required to be installed at the water inlet.
3. Please make sure the main power supply, water pressure, grounding condition, amperage/current and
wire reach the standard of installation requirement.
4. The appliance must be connected to properly grounded dedicated branch circuits of proper voltage
rating. Ground must be brought to the “ground” at the circuit breaker panel.
5. This appliance MUST be permanently connected to the fixed circuit breaker. If you don’t use the heater,
please switch off the circuit breaker.
6. DO NOT install this appliance near to tinder or strong magnetic field place. The appliance can be
installed above or under the sink, and unit must only be mounted in a VERTICAL position near by the
water fittings.
■ Installation Method
The Mini tankless electric water heater can be used for hand washing, kitchen and it can be installed above
or under the sink.
●Mounting the unit
To Next Page
Loading...
Need help?
General
