Rheem RTGH-RH11DV - Igniter

80
MaincomponentsReplacementInstructions
Chapter5ReplacementInstructions
1.Closethegasshuto󰘯valve
2.Turnthepowero󰘯.
3.Disconnectthewiringtotheigniter.
4.Removethecableconnectedtotheignitionplug.
5.Loosentwoscrewstoseparateigniterfromthe
waterheatercabinet.
6.Loosentwoscrewstoseparateigniterfromthe
bracket.
7.Separateigniterfrombracketbyunlockingthe
plastictabsonthebacksideofthebracket.
8.Replaceigniterwithnewcomponent.
9.Assembleinthereverseorderasthepartwas
removed.
10.Openthegasshuto󰘯valve.
11.Turnthepoweron.
12.Turntheunitonandensureproperoperation.
NOTE
1.Ensuretheigniterisproperlysecured.
2.Igniter