What to do if there is a Modbus data range error in Rhymebus DC Drives?
If you encounter a Modbus data range error with your Rhymebus DC Drives, it could be due to two reasons: either the data length in transmission does not match the protocol, or the data range exceeds the register length during a 'write' operation. Check these aspects to resolve the error.
What causes Modbus OP code error in Rhymebus RM6E1-4002B3 DC Drives?
A Modbus OP code error in Rhymebus DC Drives occurs when the OP code is not one of the allowed values: 03H, 06H, 08H, or 10H. Check your OP code to ensure it is correct.
What to do if Modbus register characteristics error occurs in Rhymebus RM6E1-4002B3?
A Modbus register characteristics error in Rhymebus DC Drives happens when you attempt to write into read-only registers. Ensure you are writing to the correct registers.
What is a data frame error in Rhymebus RM6E1-4002B3?
A data frame error in Rhymebus DC Drives indicates an error in the data frame of serial communication. Inspect the serial communication data frame.
What does over-bit error mean in Rhymebus RM6E1-4002B3?
An over-bit error in Rhymebus DC Drives signifies an over-bit error in the serial communication. Review serial communication settings.
Why am I getting a Modbus register error on my Rhymebus RM6E1-4002B3 DC Drives?
A Modbus register error in Rhymebus DC Drives indicates the use of non-defined registers. Verify the register addresses you are using.
Critical warnings for wiring procedures to prevent electric shock or equipment damage.
Safety warnings during drive operation, including cover removal and automatic restart.
Components required for conjunctive operation of the drive, including power source, MCCB/NFB, drive, and motor.
Considerations for safe installation, including AC power compliance, location for heat dissipation, and ventilation.
Details of main circuit terminals, wiring diagrams, SINK/SOURCE definitions, and cautions.
Overview of indicators, keys, and knob on the drive's operation panel.
Explains operation panel modes, fault messages, and switching methods.
Parameters related to system status, locking, password, power source, fault records, and default settings.
Parameters controlling start command, frequency command selection, display modes, and switching frequency.
Parameters for setting preset speeds, jog speed, reference frequency, and V/F patterns.
Parameters for holding frequency, stall prevention, motor slip compensation, and DC/dynamic braking.
Parameters for protecting the drive and motor from faults like grounding, overload, and overheat.
Parameters for configuring analog inputs, output signals, multi-function terminals, and UP/DOWN controls.
Detailed explanations for F4 protection parameters, covering grounding, overload, and overheat protection.
List of drive error trip messages, their causes, and troubleshooting steps.
To Next Page
General
