3.2 Initial Status
Switch on the device and after a few seconds’ initialization, it presents start-up pictures as
below:
DVB-T: indicate the modulation standard of this device
A: carrier output A; B: carrier output B
XXX.XX MHz indicates the current output frequency (range: 30~960MHz) of its
corresponding carrier output.
P1: Program 1; P2: Program 2; P3: Program 3; P4: Program 4
X.XX Mbps indicate the encoding bit rate of the corresponding program respectively.
Start up… Start OK…
DVB-T A XXX.00MHz
P1:X.XXMbps P2: X.XXMbps
To Next Page
Loading...