8. Troubleshooting
9. Daily Maintenance
Coin Runway Jamming:
When coin are jammed in the coin runway of the machine,
rotate the diameter knob counter-clockwise to release the left
guide plate. The jammed coin will fall into the rejected coin
box and then you can re-adjust the diameter knob again.
Centrifugal Disc Jamming:
If foreign objects are mixed with coin in the hopper, jamming
may occur between the centrifugal disc and the coin guide
plate. When jamming has occurred, remove the coins in the
hopper, open the top cover by pulling the lock lever towards
you, pull the front of allocation belt assembly towards you and
remove the foreign objects, pull up the Hook of the top cover to
unlock it and then close the top cover.
Be certain to turn the main power
off before attempting daily
maintenance.
Clean the coin passage at least
once a day with the brush sup-
plied.
Check whether the feed belt is
dirty or worn. If it is dirty, clean it;
if it is worn, replace it with a new
one.
If the machine has technical
problems (that you can not fix)
please contact your distributor.
Copyright © 2005,2006 Scales and More. All rights reserved.
To Next Page
Loading...
