920i
®
Programmable HMI Indicator/Controller
Panel Mount Enclosure Installation
This document contains drawings, replacement parts lists and instructions for installing panel mount models of 920i indicators.
See the 920i Installation Manual (PN 67887) for general installation, configuration and calibration information.
WARNING: The 920i has no on/off switch. Before opening the enclosure, ensure the power cord is disconnected from the
power outlet. Power outlet must be located near the product.
This unit uses double pole/neutral fusing which could create an electric shock hazard. Procedures requiring work inside
the indicator must be performed by qualified service personnel only.
IMPORTANT: Use a wrist strap for grounding and to protect components from electrostatic discharge (ESD) when working
inside the indicator enclosure.
Figure 1. Panel Cutout for Panel Mount Enclosure
Illustration is not to scale, dimensions
are for reference only.
Interior Housing
(Dotted Line)
Panel Cutout
(Dashed Line)
Outer Perimeter of
Exterior Faceplate
(Solid Line)
PN 69989 Rev CJanuary 5, 2023
To Next Page
Need help?
General
