Why is the Rice Lake Revolution 680 Synergy Plus Accessories serial port not responding?
If your Rice Lake Accessories serial port isn't responding, ensure the port INPUT parameter is set to CMD for command input. A configuration error might be the reason for this issue.
What to do if Rice Lake Revolution 680 Synergy Plus Accessories display reads 0.000000?
If your Rice Lake Accessories display reads 0.000000, make sure all cables/wires are connected for the pulse input and/or load cell. If the connections are correct, cycle the power to the device.
How to troubleshoot Rice Lake Revolution 680 Synergy Plus Accessories 80 that does not power up?
If the Rice Lake Accessories 80 does not power up, check the power supply and ensure AC power is present (breaker not tripped, unit plugged in). The power supply outputs should be around 12 VDC; replace the power supply if it's bad.
What to do if I get a battery backed corrupt error message at startup on Rice Lake Revolution 680 Synergy Plus Accessories?
If you receive a battery backed corrupt error message at startup for your Rice Lake Accessories, perform a configuration reset and then check for a low battery warning on the display. If the battery is low, replace it, perform another configuration reset, and then reload your files/configuration.
What to do if Rice Lake Revolution 680 Synergy Plus shows option card failure?
If you are experiencing an option card failure with your Rice Lake Accessories, disconnect the power, remove the card from its slot, reinstall it, and then reapply power. The cause may be a defective card or slot.
What causes Rice Lake Accessories /D scale out of range?
If your Rice Lake Accessories /D scale is out of range, check the source scale for proper mechanical operation, inspect the load cell and cable connection, check the 680 operation with a load cell simulator, and verify the status of sense settings. The cause may be a bad load cell.
How to fix Rice Lake Revolution 680 Synergy Plus when I cannot enter setup mode?
If you cannot enter setup mode on your Rice Lake Accessories, test the switch. The cause may be a bad switch.
What does 'vvvvvv ro vvvvvv' mean on Rice Lake Accessories?
If you see 'vvvvvv ro vvvvvv' on your Rice Lake Accessories, check the scale. For out-of-range conditions in the total scale display, check all scale inputs for positive weight values. This may be due to an over or under range scale condition.
General| Brand | Rice Lake |
|---|---|
| Model | Revolution 680 Synergy Plus |
| Category | Accessories |
| Language | English |
Defines safety signals and provides general safety instructions for operating the indicator.
Details how to access setup mode using the setup switch.
Access to configuration and settings for up to eight setpoints.
Steps to perform calibration using the front panel controls.
Commands to display or change configuration parameter values.
To Next Page