TECH MODE
SM 5-1 B273
Service
Program
Mode
5. SERVICE PROGRAM MODE
5.1 TECH MODE
Tech Mode allows for checking of the machine and various tests to resolve
problems. The machine can still operate normally when Tech Mode.
5.1.1 HOW TO ENTER AND EXIT TECH MODE
Perform the following to enter tech mode:
The LED shows “Tech” when the machine enters Tech Mode.
Press the “Menu” button to access the Tech mode menus.
To exit Tech Mode, press again.
What you can do in Tech Mode:
Function Item Contents
Send Level 9-15 dBm
Dial Mode Tone/Pulse
Modem Speed
33.6 / 28.8 / 14.4 / 12.0 / 9.6 / 4.8
(K bps)
Error Rate 5% / 10%
Customer No.
Customer Name
Service No.
Notify Toner
Serial No.
Clear All Memory Select Country ( 5.5)
Total Page CNT
FLT Scan CNT
ADF Scan CNT
Clear Count
Enter Password
(1934 enter)
Used Toner CNT
Flash Upgrade Local / Remote
Silence Time 12 Sec / Unlimit / Off
Data Setup
Ignore Toner On /Off
Switch Test
Modem Test
Dram Test OK / NG
Rom Test Flash / Engine versions
Pattern Test 5.1.3
Machine Test
Shading Test
Protocol Protocol List Report
System Data System Data List
To Next Page
Loading...
