14. Press [FTP].
15. Press [Change] under "Server Name".
16. Enter the server name, and then press [OK].
17. Press [Change] under "Path".
18. Enter the path, and then press [OK].
You can enter an absolute path, using this format: "/user/ home/username"; or a relative path, using
this format: "directory/sub-directory".
If you leave the path blank, the login directory is assumed to be the current working directory.
You can also enter an IPv4 address.
You can enter a path using up to 128 characters.
19. To change the port number, press [Change] under "Port Number".
20. Enter the port number using the number keys, and then press the [
] key.
You can enter 1 to 65535.
21. Press [Connection Test] to check the path is set correctly.
22. Press [Exit].
If the connection test fails, check the settings, and then try again.
23. Press [OK].
24. Press [Exit].
25. Press the [User Tools/Counter] key.
• To register the name, see "Registering Names".
• You can enter up to 64 characters for the user name.
• You can enter up to 64 characters for the password.
• You can enter a server name using up to 64 characters.
• If User Authentication is specified, contact your administrator.
7. Registering Addresses and Users for Facsimile/Scanner Functions
268