18. Press [Change] under "User Name".
When [Kerberos Authentication], [Digest Authentication], and [Cleartext Authentication] is selected
for the authentication setting, use the administrator account name and password. Do not enter the
administrator account name and password when using authentication for each individual or each
search.
19. Enter the user name, and then press [OK].
Procedures for the user name setting differ depending on server environment. Check your server
environment before making the setting.
Example: Domain Name\User Name, User Name@Domain Name, CN=Name, OU=Department
Name, DC=Server Name
20. Press [Change] under "Password".
21. Enter the password, and then press [OK].
The user name and password are required for administrator authentication to access the LDAP server.
You can set the user name and password in this machine's Address Book to allow individual
authentication access to the LDAP server. Use Administrator Tools to select the user name and
password you want to use.
If you select [Digest Authentication] or [Cleartext Authentication], proceed to step 23.
22. Select the Realm.
Programming the LDAP server
95
To Next Page
Loading...
Need help?
General