2
Setting Up the Machine on a Network
This section describes the network settings you can change with User Tools (Sys-
tem Settings). Make settings according to functions you want to use and the in-
terface to be connected.
Important
❒ These settings should be made by the systems administrator, or after consult-
ing with the systems administrator.
Initial Settings Overview
❖ Interface Settings
Menu Description
Machine IPv4 Address Specifies the machine IPv4 address and sub-
net mask in the network environment.
IPv4 Gateway Address Configure the gateway address for the rout-
er or host computer used as a gateway.
Machine IPv6 Address Specifies the machine IPv6 address and sub-
net mask in the network environment.
IPv6 Gateway Address Configure the gateway address for the router
or host computer used as a gateway.
IPv6 Gateway Address Specifies the automatic configuration of the
IPv6 Stateless Address.
DNS Configuration Make settings for the DNS server.
DDNS Configuration Specifies the DDNS settings.
Domain Name Specifies the domain name.
WINS Configuration Specifies the WINS server settings.
Effective Protocol Select the protocol to use in the network.
NCP Delivery Protocol Select the protocol for NCP delivery:
NW Frame Type Select the frame type when you use NetWare.
LAN Type Select interface, IEEE 802.11b (wireless LAN)
or Ethernet when you have installed the op-
tional IEEE 802.11b interface unit.
Ethernet Speed Set the access speed for networks.
Ping Command Check the network connection with ping
command using given IP address.
SMB Computer Name Specifies the SMB computer name.
SMB Work Group Specifies the SMB work group.
Permit SNMPv3 Communication Set the encrypted communication of SNMP v3.
Permit SSL / TLS Communication Set the encrypted communication of
SSL/TLS.
Host Name Specify the host name.
To Next Page
Loading...
Need help?
General
