• Vertical: Std. Ppr Tray
• Vertical: Opt. Ppr Tray
• Vertical: Bypass Tray
• Vertical: Back Side
Curl Prevention
You can control the fuser temperature to prevent paper from curling. Use this mode only when paper
misfeed occurs frequently during duplex printing.
Default: [Off]
• On
• Off
General Settings
Replacement Alert
Use this function to specify the timing of when the Alert Indicator will light up to prompt the user to
replace supplies.
• Fusing Unit
Default: [Normal]
• Notify Sooner
• Normal
• Notify Later
Supply End Option
You can specify whether or not to continue printing after the following components have exceeded
their recommended service life.
Default: [Continue Printing]
• Continue Printing
• Stop Printing
Display Supply Info
You can select whether or not the amount of toner is displayed on the initial screen.
Default: [On]
• On
• Off
Menu Protect
You can select whether or not to protect the menu settings. If you enable this setting, you must specify
a protection level.
Maintenance Menu
93
To Next Page
Loading...
