Technical Bulletin PAGE: 1/3
Model: Plockmatic Booklet Maker BK5010 system Date: 3-Jul-06 No.: RZP18 002
Subject:. BF5010 Tilt the Machine Warning Prepared by: Göran Sandén
From: PLOCKMATIC Europe/Asia, USA
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other
SYMPTOM: If not following each step in the attached update of the service manual page
BF3-6 to BF3-7 when tilting the BF5010 there is a risk of personal injury.
CAUSE: The Service Manual lacks warnings and procedure is not fully up to date
regarding BF5010 in relation to BF90.
SOLUTION: Warning
Before tilting the BF5010 make sure pivot screws [E] are NOT tightened.
They should be loosened about ½ turn.
When tilting the BF5010, make sure to fasten and tighten BOTH screws
[G], one on each side.
Next Service Manual update will include the updated instruction
attached.
For the full updated procedure, see attached instruction.
[E]
[G]