Need help?Do you have a question about the Ricoh U-C1 B051 and is the answer not in the manual?
General| Product Type | All-in-One Printer |
|---|---|
| Functions | Print, Copy, Scan |
| Print Technology | Inkjet |
| Scanner Type | Flatbed |
| Copy Resolution | Up to 600 x 600 dpi |
| Paper Capacity | 100 sheets |
| Media Types | Plain Paper, Photo Paper, Envelopes |
| Connectivity | USB 2.0 |
| Operating System Compatibility | Windows |
Precautions to prevent physical harm during copier operation and maintenance.
Guidelines for safe electrical installation and maintenance of the copier.
Prohibits field repair of laser optical units; directs return to factory for repair.
Specifies environmental, electrical, and space requirements for machine installation.
Details on copier installation, including power sockets for peripherals.
Explains the step-by-step process of how a copy is made.
Describes the parameters and steps involved in process control for image quality.
Details the scanning system, including drive mechanisms and size detection.
Explains image processing steps like shading, color correction, and filtering.
Overview of preventive maintenance for the main unit.
Table outlining preventive maintenance tasks for various components based on print counts.
Step-by-step procedure for replacing the laser unit.
Procedure to adjust the image skew by repositioning the laser optics housing.
Corrects density differences between the left and right sides of the paper.
Adjusts laser beam pitch to eliminate vertical black stripes.
Guide for replacing development units, including starter toner cartridge information.
Procedure for removing and handling the Photoconductor Unit (PCU) assembly.
Procedure for removing and replacing the fusing unit.
Adjustments for print registration, including leading edge and side-to-side.
Adjusts the magnification in the sub-scan direction.
Adjusts scanner registration for platen mode.
Automatic calibration of printer gamma curve for color accuracy.
Fine-tuning printer gamma curves for optimal print output.
Adjusts scanner white level when it is not correct.
Conditions and reset procedures for service call errors.
List of service call codes, symptoms, and possible causes.
Lists common sensor defects, their conditions, and symptoms.
Overview of the Service Program mode and its operation.
Steps for entering and exiting the Service Program mode.
SP table for feed adjustments, including lead edge and side-to-side registration.
Enables/disables user code, key counter, and coin lock for various modes.
Checks the status of various sensors and switches in the main machine.
Tests the operation of main machine components like motors and clutches.
Procedure for downloading firmware modules to the machine.
Procedure for backing up and restoring NVRAM data using a flash memory card.
Resets system settings to their factory defaults.
Resets copier settings to their factory defaults.
Details the six steps involved in process control.
Improves image reproduction for high-density areas.
Compensates for light emission level differences in scanned images.
Corrects scan line and CCD perpendicularity for accurate dot positioning.
Synchronizes RGB signals by storing lines in memory.
Details the power supply, grid, wire, and cleaning mechanism for the charge corona unit.
Safety switch mechanism to prevent laser emission when covers are open.
Explains methods for detecting toner end and near-end conditions.
Provides general specifications for the main unit, including configuration and paper sizes.
To Next Page