Ricoh U-C1 B051 - 5. SERVICE TABLES; 5.1 SERVICE PROGRAM MODE; 5.1.1 SERVICE PROGRAM MODE OPERATION

26 July 2002 SERVICE PROGRAM MODE
5-1
Service
Tables
5. SERVICE TABLES
5.1 SERVICE PROGRAM MODE
!
CAUTION
Do not turn off the main power switch while the power LED ( ) lights or
flashes. Doing so may severely damage the hard disk or the memory of the
copier. Before turning off the main power switch, press the operation
power switch, and wait for the power LED to go out.
NOTE: The main power LED lights or flashes when:
1) the platen cover or ARDF is open
2) the hard disk or memory is accessed
3) the copier is communicating with another device
5.1.1 SERVICE PROGRAM MODE OPERATION
Starting the SP mode
1. Press the clear modes key.
"
2. Type “107” at the numeric keypad.
#$%
3.
Press the clear/stop key and hold it down until the screen
display changes (for about 3 seconds).
&
4. Touch “Copy Sp” on the touch screen. Copy SP
Quitting the SP mode
1. Touch “Exit” on the touch screen until the screen
display changes.
Exit
2. Touch “Exit” on the touch screen until the screen
display changes.
Exit