26 July 2002 DUMMY
5-77
Service
Tables
No. What It Initializes Comments
11 NCS
(Network Control Service)
Initializes the system defaults and interface settings
(IP addresses also), SmartNetMonitor for Admin,
WebStatusMonitor settings, and the TELNET
settings.
12 R-FAX Initializes the job login ID, SmartNetMonitor for
Admin, job history, and local storage file numbers.
14 DCS
Initializes the DCS (Delivery & Receive Control Server)
settings
15 UCS
Initializes the UCS (User Directory Control Server)
settings.
5. Touch EXECUTE, and turn the main switch off and on.
6. Download the NVRAM data from a flash memory card (☛ 5.2.2).
Without Using a Flash Memory Card
If there is no flash memory card, follow the steps below.
1. Execute SP5-990 to print out all SMC data lists.
2. Open SP5-801.
3. Select the number for the item that you want to initialize.
4. Press EXECUTE and turn the main switch off and on.
5. Make sure that you do the following:
• Do the printer and scanner registration and magnification adjustments (☛
“Copy Adjustments” in chapter 3, “Replacement and Adjustment”).
• Do the touch screen calibration (☛ “Touch Screen Calibration” in chapter 3,
“Replacement and Adjustment”).
• Referring to the SMC data lists, re-enter all values that have been changed
from their factory settings.
• Do the white level adjustment (☛ Section 3.14 Standard White Density
Adjustment)
6. Check the copy quality and the paper paths, and do any necessary
adjustments.
To Next Page
Loading...
