IMAGE FUSING AND PAPER EXIT 26 July 2002
6-70
6.12.6 ENERGY SAVER MODES
Overview
When the machine is not being used, the energy saver function reduces power
consumption by decreasing the fusing temperature.
This machine has three types of energy saver mode as follows.
1) Panel-off mode (1 & 2)
2) Low power mode
3) Auto Off mode
These modes are controlled by the following UP and SP modes.
• Panel off timer: User Tools – System Settings – Key Operator Tools – Panel
Off Level
• Panel off level (1 or 2): User Tools – System Settings – Timer Setting – Panel
Off Timer
• Energy saver timer: System Settings – Timer Setting – Energy Saver Timer
• Auto off timer: User Tools – System Settings – Timer Setting – Auto Off
Timer
• Auto off disabling (SP mode): Set SP5-305 to "disable." This disables the
auto off mode.
Stand-by Mode
Auto Off Mode
Key Operation
Energy Saver Key ON
-or-
Panel Off Timer (10 s to 999 s / Default: 10 s)
Panel-Off Mode (1&2)
Low Power Mode
Energy Saver Timer
(1min. to 240 min. / Default: 15 min.)
Return Time Less Than 3s Panel-Off Level 1
Return Time Less Than 10s Panel-Off Level 2
Key Operation
Return Time Less Than 30 s
Off Mode
Off Stand-by Mode
FAX: RX, etc.
Printer Data in
After Printing
Operation Sw. Off
-or-
Auto Off Timer
(1 mni. to 240 min. / Default: 60 min.)
Operation Sw. Off
-or-
Auto Off Timer
(1 mni. to 240 min. / Default: 60 min.)
Operation Sw. Off
-or-
Auto Off Timer
(1 mni. to 240 min. / Default: 60 min.)
Return Time Less Than 99 s
Operation Sw. On
Platen Cover Open / Close
Original Set ADF
B051D903.WMF
To Next Page
Loading...
